DX ENGINEERING DXE-RPA-1 Preamplifier

( Brand: Dx Engineering ), ( Manufacturer Part Number: DXE-RPA-1 )

Review DX ENGINEERING Rpa-1 Receive Preamplifier

Meticulous craftsmanship and durable, robust components enable these preamplifier to withstand high signal levels, providing superior dynamic range third-order intercept performance that actually makes rpa-1 better than most receiver transceiver front-ends.

Dx engineering rpa-1 receive preamplifier use rca-type phono jacks and CATV type-f female connectors for the input output connections, to prevent accidental connection transmitting devices. With Dx engineering receive preamplifier, you can be ensured of the best possible results for your hf, low band, am Ding and SQL operational needs. Receive device height : in. Dx engineering rpa-1 receive preamplifier are the best low-noise receiver preamps available period.

75 NV wide, each with. Indoor, at the radio installation is recommended for rpa-1 preamps, since cable losses in 300 khz - 35 MHz frequency range do not normally require an outdoor or antenna-mounted preamplifier.

However, outdoor installation with the appropriate weather protection is possible, as rpa-1 preamplifier may be internally modified by user to powered through coaxial feed line, using a Dx engineering feed line voltage injector. 5 db, from 300 khz through 35 MHz dynamic range im3 at 500 Hz Be: 110 db or greater output third order intercept: 43 DBMS noise figure: 5 db compression: 1 at 26 DBMS. 5 db dynamic range im3 at 500 Hz Be: over 110 third order intercept ip3: 43 DBMS noise figure: 3.

These high performance devices must be powered with a well filtered and regulated dc power supply will offer maximum at 12 to 18v input. Receive device depth: 5.

They were exclusively researched and developed with an advanced push-pull amplifier design that eliminates harmonic distortion a common problem in many other preamplifier.

Dimensions do not include connectors or cable clearance. A high quiescent current increases the rpa-1 preamps ability to handle strong signals without distortion or overload.

For operator convenience, rpa-1 receive preamplifier feature a built-in relay that automatically bypasses the preamplifier circuit when dc power is removed. Rpa-1 receive preamplifier are optimized for the 300 khz through 35 MHz frequency range.

These units are not designed to be connected a transmitting RF feed line GA - 7 TX in. Here are important specifications for these incredible Dx engineering rpa-1 receive preamplifier: gain: 16 db, - Notes: us pat.

Instructions are included in the rpa-1 manual. 4 w output power requirement: 12-18v dc ma maximum input: 2.

part #: dxerpa1 prices

• $213.98-$224.99

specifications radiparaccessori:

• brand: Dx Engineering
• mpn: Dxe-rpa-1

Shipping radiparaccessori:

• type: Calculated
• handling: 3 days

Returns radiparaccessori:

• policy: no returns

General radiparaccessori:

• consumer electronics > radio communication > partsaccessories > other parts accessories
• in stock: Yes
• condition: New other see details

Ratings:

1. Good seller, fast ship, high integrity, recommend highly 03-05-18
2. PERFECT; THANKS; GREAT ; A 03-01-18
3. Easy Purchase good communication. Only issue is CW tone robotic? 03-09-18
4. AAAAAAAAAAAAAAAAAA 03-10-18
5. Good dealer 03-14-18

Payments radiparaccessori:

• PayPal

Seller radiparaccessori:

• zipcode: 44260
• city: Mogadore, Ohio

Offer radiparaccessori:

• bids: 0
• Sold: 0
• quantity: 1
• Started: March 16, 2018, 6:16 am
• best offer: false
• min. bid: $49.95

Dx Engineering DXE-RPA-1 Is Similar To:

• 300-ohm Dxe-ll300 Dx Engineering Ladder Line Total Of 372 Feet Length (40.4% similar) 88 VF, 372 ft. Dx Engineering 300 ohm ladder line ladder line, 300 ohms, window open wire, 18 wag stranded CVS, 2500 w. Dx Engineering 300 ohm ladder line has 272 ohm nominal impedance and an 88 percent velocity factor. Dx Engineering 300 ohm ladder line is rated for over full legal power and is ...(October 11th, 2016)
• Dxe-ps-2b Dx Engineering Pro-stack Broadband Antenna Phasing Switch (46.4% similar) The default is both output ports in phase. Just connect your antennas to the phasing switch controller with equal length 50 ohm lines. Features power handling up to 5 kw broadband coverage on meters high impact RF shielded weatherproof housing high RF tolerant, silver PDF so 239 uhf female proven ...(September 16th, 2016)
• Lc-1-32s Dx Engineering Speech Compressor For Collins 32s Series Serial 437 (45% similar) Please see the photos to get a better understanding of the quality of this unit. Physically the unit is in very good condition for its age with only minor wear a small dent on one corner. Dx Engineering LC 1/3 2s speech compressor for Collins 32S series serial condition used very good this Dx ...(July 14th, 2016)
• Dxe-cc-4sqr Dx Engineering Transmit Control Console (54.2% similar) They have four-directional momentary contact switches, Omani switch, and four green leds to show the systems' current transmit receive direction. 8 CDC control console width in. Dxe:transmit four-square control console Dx Engineering transmit consoles are designed as replacements for the TFS4 ...(June 18th, 2018)
• Dxe-ps-3bdin Dx Engineering Ps-3b Pro-stack (59.1% similar) This eliminates common requirements of using mixtures 75 ohm and 50 phasing or delay cables for impedance matching. PS-3B pro-stack three antenna phasing unit Dx Engineering units offer the ultimate performance for combining identical yogi or log periodic directional antennas and may be used ...(November 29th, 2017)
• Dxe-rfs-3 Dx Engineering Receive Four-square (71.9% similar) 75 NV better control of phase and currents provides a cleaner pattern than those found on available transmit four square arrays. The RFS-2S use sealed relays sized for receiving applications with silver contacts to prevent oxidation and contamination. Relays with brass contacts can oxidize, leading ...(November 29th, 2017)
• Dxe-tfs4-160b Dx Engineering Tfs4 Series (58.8% similar) The systems allow operator to receive or transmit with gain in any one of four directions a good front-to-back ratio, and then single Omani-directional pattern, back again, push button. Hybrid unit height in. 375 in GA - 7 TX below the relay unit. This combination is a great tool, which permits ...(November 29th, 2017)
• Dx Engineering Bal050-h05-a Maxi-core Ham Radio Balun (42.9% similar) Enclosure material: aluminum. Core type: patented maxi-core. You are purchasing 1 used Dx Engineering BAL050-H05-A maxi-core ham radio 1:1 baling. Termination impedance: 50 ohms. Specifications: frequency range: 1.8 - 30 MHz. Made exclusively by Dx Engineering. Internal dc shield ground and arc gaps...(November 7th, 2023)
• Dx Engineering Rr8b-sd Ec-8 Ham Radio Remote Coax Switch System Very Nice (39% similar) The bottom line is this. That includes manuals, packaging, power cords, etc. This Dx Engineering remote coax switch set consists of the control box EC-8 and relay RR8B-SD. No cables are included. If you do not see it in the photos, is likely included sale...(October 28th, 2025)
• Dx Engineering Dxe-ut-80p Ham Radio Connector Assembly Tool Nice (40.4% similar) If you do not see it in the photos, is likely included sale. That includes manuals, packaging, power cords, etc. The bottom line is this. This connector is in good cosmetic condition...(February 8th, 2026)
• Dx Engineering Dxe-radp-3 Ham Radio Radical Plate Great Condition (43.6% similar) That includes manuals, packaging, power cords, etc. The bottom line is this. This plate is in good cosmetic condition. If you do not see it in the photos, is likely included sale...(February 14th, 2026)